Wings, doors, bonnets and outer sills
LH front - variant without bumper bracket
126, 1st Series (1972-76)
Required: 1
RH front - variant without bumper bracket
126, 1st Series (1972-76)
Required: 1
LH front - variant with bumper bracket
126, 2nd Series (1976-87)
Required: 1
LH front - variant with bumper bracket
126, 2nd Series (1976-87)
Required: 1
for models with narrow bumpers
126, 1st Series (1972-76) plus 2nd Series to December 1984
Required: 1
for models with wide rubber bumpers
126, 2nd Series from December 1984 on
Required: 1
LH rear, section below side window - identified by small air intake
126, 1st Series (1972-76) plus 2nd Series to December 1984
Required: 1
RH rear, section below side window - identified by small air intake
126, 1st Series (1972-76) plus 2nd Series to December 1984
Required: 1
LH rear, section below side window - identified by large air intake
126, 2nd Series from December 1984 on
Required: 1
RH rear, section below side window - identified by large air intake
126, 2nd Series from December 1984 on
Required: 1
LH rear - identified by large air intake
126, 2nd Series from December 1984 on
Required: 1
RH rear - identified by large air intake
126, 2nd Series from December 1984 on
Required: 1
LH - variant for models with quarter lights. If necessary, adjust the fastening holes for plastic trim strips accordingly.
Required: 1
LH - variant for models without quarter light and lower bead
126 EL and ELX (1994-2000)
Required: 1
RH - variant for models with quarter lights. If necessary, adjust the fastening holes for plastic trim strips accordingly.
Required: 1
RH - variant for models without quarter light and lower bead
126 EL and ELX (1994-2000)
Required: 1
LH door. If necessary, adjust the fastening holes for plastic trim strips accordingly.
Required: 1
RH door. If necessary, adjust the fastening holes for plastic trim strips accordingly.
Required: 1
LH 'A' post - upper panel with cut-out for side indicator
Required: 1
RH 'A' post - upper panel with cut-out for side indicator
Required: 1
rear end - lower panel with cut-out for LH rear lamp
Required: 1
rear end - lower panel with cut-out for RH rear lamp
Required: 1
