Heater assembly - from October 1985 to November 1986
heater unit to front panel
Required: 1
blower motor
Required: 1
Required: 4
between heater matrix and pipe to water pump
Models with carburetter engine
Required: 1
top position. Heater to pipe
Models with carburetter engine
Required: 1
worm type - for hoses from 7/8" to 1.1/4" diameter
Models with carburetter engine
Required: 2
worm worm drive type with a 12 mm wide stainless steel band - for hoses from 25 to 40 mm diameter
Models with carburetter engine
Required: 4
water outlet to inlet manifold
Models with carburetter engine
Required: 1
water pump to heater pipe
Models with carburetter engine
Required: 1
driver and passenger side
Required: 1
centre position
Required: 2
demister hose
LHD models
Required: 1
demister hose
RHD models
Required: 1
upper position, centre position
Required: 2
upper position, LH
Required: 1
upper position, RH
Required: 1
retaining ventilation nozzle
Required: 8
demister hose to heater unit
Required: 2
Required: 1
behind the dash
Required: 1
under dash
Required: 2
matt finish. Side panel, RH
Required: 1
matt finish. Side panel, RH
Required: 1
behind the grille. Side panel, RH
Required: 1
behind the grille. Side panel, LH
Required: 1
pad air intake bonnet
Required: 3
air intake filter element in scuttle panel, centre fixing
Required: 3
for the filter under the bonnet air intake grille, LH bracket
Required: 1
for the filter under the bonnet air intake grille, RH bracket
Required: 1
retaining filter pad
Required: 3
air grille, centre position
Required: 2
air grille, LH position
Required: 1
air grille, RH position
Required: 1
rear passenger
Required: 2
worm worm drive type with a 12 mm wide stainless steel band - for hoses from 25 to 40 mm diameter
EFI models
Required: 8
