SU-HS6 internal carburettor - BJ7
with piston for SU-H6 and HS6 carburettors
Required: 2
assembly. For SU-HS carburettors with fixed metering needle
Required: 2
front carburettor - identification: orange marking
Contains illustrations 19 to 22
Required: 1
rear carburettor - identification: yellow marking
Contains illustrations 19 to 22
Required: 1
throttle spindle. For bodies with worn cast in bushes, useable on SU and Zenith Stromberg carburettors with 5/16" throttle spindle
For bodies with worn cast in bushes
Required: 4
for SU-H, SU-HD and SU-HS type carburettors - superior replacement of needle valve and seat
Superior replacement of needle valve and seat
Required: 2
for SU HS type carburettor - uprated 'unsinkable' type, made from closed cell Nitrile rubber foam, resistant to modern ethanol based fuels
Required: 2
made from nitrile rubber. Inner diameter: 5/16", outer diameter: 1/2", braided with zinc plated wire
Braided with zinc plated wire
Required: 1
rear carburettor
Required: 1
choke lever guide - complete kit with sleeve and washers
Required: 2
with link, front carburettor - original type
Alternatives
Required: 1
with link, front carburettor - replacement
Alternatives
Required: 1
with link, rear carburettor - original type
Alternatives
Required: 1
with link, rear carburettor - replacement
Alternatives
Required: 1
front carburettor
Required: 1
rear carburettor
Required: 1
for two SU-HS6 type carburettors. Comprising service kit plus throttle discs and throttle spindles
Comprising service kit 214284 plus throttle discs and throttle spindles
Required: 1
for SU-H4 carburettors. Chromed with 78 mm total height
Construction height: 78 mm
Required: 2
for SU-HS4 and HS6 carburettors. Chromed with 71 mm total height
Construction height: 71 mm
Required: 2
